Model: GPHM56031 | Type: R-32 packaged heat pump | Nominal size: 5 ton
Goodman GPHM5 is a higher-efficiency R-32 packaged heat pump (all-in-one outdoor unit) built for ducted cooling and heating with horizontal or downflow airflow configurations. It’s designed for applications where the outdoor unit connects directly to supply/return ductwork. Sizing should be done with a proper load calculation (tonnage is capacity, not a guaranteed square-foot number).
Specs at a glance
- Efficiency ratings: 15.4 SEER2, 11.6 EER2, 7.00 HSPF2
- Cooling capacity: 58,000 BTU/h total / 45,000 BTU/h sensible
- Heating capacity: 58,000 BTU/h @ 47°F (COP 3.60); 26,000 BTU/h @ 17°F (COP 1.86)
- Compressor: Scroll (Two-stage); RLA 27.07, LRA 178
- Indoor airflow: 1,950 nominal CFM with multi-speed ECM blower (5 speeds); blower FLA 6.9; motor 1 HP
- Refrigerant: R-32; factory charge 185 oz (A2L / mildly flammable—install and service per applicable codes by qualified technicians)
- Electrical: 1-phase 208-230V, 60 Hz; minimum circuit ampacity (MCA) 39; max overcurrent protection (MOP) 60
- Sound rating: 78 dB
- Weight (listed): 688 lb
- Certifications: AHRI Certified; UL Listed
Cooling details
Provides 58,000 BTU/h of total cooling with 45,000 BTU/h of sensible capacity. EER2 (11.6) is measured at a single test condition, while SEER2 (15.4) represents seasonal efficiency over a range of conditions—use both to compare models and estimate operating costs.
Heating details
Heat pump output is listed at two common rating points: 58,000 BTU/h at 47°F and 26,000 BTU/h at 17°F. The COP values (47°F: 3.60, 17°F: 1.86) indicate heating efficiency at those points. In colder climates, many installations add a field-installed electric heat kit for auxiliary/emergency heat.
Airflow, comfort & filtration
- Multi-speed ECM indoor blower helps match airflow to duct design and comfort needs.
- Convertible airflow supports horizontal or downflow duct connections (field-configurable).
- Metering device: evaporator TXV; condenser TXV.
- Filtration approach depends on your installation (internal/external filter racks are available as accessories).
Construction & durability
- Condenser coil: copper tube/aluminum fin. Evaporator coil: aluminum-copper (5 ton model).
- Liquid-line filter drier included.
- Compressor: high-efficiency two-stage scroll (2.5–5 ton).
- Heavy-gauge galvanized-steel cabinet with two-tone Architectural Gray powder-paint finish and foil-faced internal insulation (reinforced with fiberglass scrim).
- Fully insulated air-handling compartment with access panels and louvered condenser coil protection.
- Meets cabinet air leakage requirements when tested to ASHRAE Standard 193; when properly anchored, meets 2023 Florida Building Code unit integrity requirements for hurricane-type winds (anchor bracket kits available).
Installation planning (verify before ordering)
- Chassis size: X-Large
- Unit dimensions: W 73⅜ in × D 47⅝ in × Height A 39 in (Height B 43½ in)
- Duct openings: Supply 17 x 12 (W×H) / Return 11 x 25 (W×H)
- Condensate drain: 3/4" NPT female connection.
- Downflow installs: manufacturer notes require horizontal duct covers plus either a downflow conversion kit or a downflow economizer.
- Electrical planning: use MCA/MOP values for breaker and wire sizing, and always verify against the unit’s nameplate (S&R plate). Use time-delay fuses or HACR-type breakers as required.
Common add-ons (sold separately)
- Electric heat kit (field-installed) for auxiliary/emergency heat
- Economizer options (fresh air / ventilation) — varies by chassis
- Roof curb and concentric kit options — varies by chassis
- Filter rack options (internal downflow or external horizontal)
- Additional 5-ton specific curb/damper/economizer options are listed in the spec sheet accessory table.
What’s included: packaged heat pump unit only (factory charged). Thermostat/controls, ductwork, curb, economizer, and electric heat kit (if needed) are typically purchased separately and installed by a licensed HVAC professional.
Let customers speak for us
What customers think about the store
Store offers excellent customer service with fast shipping and competitive pricing. Products arrive well-packaged and on time. Knowledgeable support staff assist with installations and technical questions. Customers appreciate quality HVAC systems, mini-splits...