Goodman 2-Ton 19.0 SEER2 R-32 Central Heat Pump Split System with Evaporator Coil & Modular Blower
This AHRI-certified central heat pump split system that pairs the Goodman GZV7SA2410 2-ton R-32 variable-speed inverter-driven heat pump condenser with the CAPEA3626C3 upflow/downflow evaporator coil (internal EEV) and the MBVK16CP1X00 multi-positional variable-speed modular blower. Rated at up to 19.0 SEER2 / 8.6 HSPF2 with 23,200 BTU/h cooling and 23,200 BTU/h heating capacity (47°F), this system uses R-32 refrigerant (GWP 675) — a lower-GWP alternative to R-410A. The outdoor unit features a variable-speed swing compressor, EEV metering, and quiet-mode operation as low as 45 dBA. AHRI Certificate Number: 215433908. ENERGY STAR® Cold Climate certified and recognized as ENERGY STAR Most Efficient.
Note: If you would like to review the manufacturer Product Specifications, Warranty, Brochure, etc., for this system, please refer to the 'Resources (System Manuals and Warranty)' Tab above on this page.
System Components
- GZV7SA2410 — Goodman 2-Ton R-32 Variable-Speed Inverter-Driven Side-Discharge Heat Pump Condenser (208-230V/1Ph/60Hz) | Dimensions: 36⅝"W x 13¾"D x 27⅜"H | Equipment Weight: 132 lbs
- CAPEA3626C3 — Goodman Upflow/Downflow Cased Indoor Evaporator Coil with Internal EEV | Dimensions: 21"W x 21"D x 26"H | Ship Weight: 57 lbs
- MBVK16CP1X00 — Goodman Multi-Positional Variable-Speed ECM Modular Blower | 21"W x 21"D x 30"H | ¾ HP Motor | Ship Weight: 80 lbs
🛠 Pro-Installer Tip: Two-Piece System Alignment & Communicating Setup
Technical Friction: The CAPEA3626C3 coil mated to the MBVK16CP1X00 modular blower creates a two-piece indoor section. Physical alignment between the coil drain pan and blower cabinet transition is critical — even a ¼" offset at the seam can cause condensate to pool at the joint rather than draining properly, especially in horizontal installations where gravity assistance is minimal.
Long-Term Prevention: After assembly, run the system in high-speed cooling for 20 minutes and inspect the coil-to-blower seam for any condensate weeping. Apply foil-faced mastic tape at the joint and verify the secondary drain pan (if required by code for attic installations) is properly sloped. This prevents water damage callbacks that typically appear 2–3 months into the first cooling season.
Expert Validation: Use a digital torpedo level to confirm ¼" per foot slope toward the primary drain connection. Verify the communicating link between the modular blower and the GZV7SA2410 outdoor unit is established via the two-wire ComfortBridge connection — the blower’s diagnostic LED should show a steady heartbeat pattern confirming communication.
Professional Standard: Per the 2024 UMC and local amendments for A2L refrigerants, the R-32 sensor integrated into the CAPEA3626C3 coil must be verified operational before completing commissioning. Confirm EPA 608 certification is current for all technicians handling R-32 refrigerant.
Key System Benefits
- ✅ High Efficiency: Rated at up to 19.0 SEER2 / 8.6 HSPF2, this system meets or exceeds DOE 2023 minimum efficiency standards and qualifies for ENERGY STAR Cold Climate certification, demonstrating reliable heating performance down to 5°F ambient (15,800 BTU/h at 5°F).
- ✅ Lower-GWP Refrigerant: R-32 has a Global Warming Potential (GWP) of 675, approximately 68% lower than R-410A (GWP 2,088). This supports federal HFC phasedown mandates under the AIM Act and may qualify for additional regional utility rebates.
- ✅ Variable-Speed Comfort: The inverter-driven swing compressor modulates capacity from approximately 30% to 100%, reducing temperature swings and improving humidity control compared to single-stage or two-stage systems. The digitally commutated fan motor provides quiet, efficient outdoor airflow.
- ✅ Quiet Operation: Normal-mode cooling sound power of 67 dBA with a three-level quiet mode that can reduce outdoor noise to as low as 45 dBA — suitable for installations near bedrooms, patios, or properties with local noise ordinances.
Technical Specifications
| Specification | Value |
|---|---|
| AHRI Certificate Number | 215433908 |
| System Type | Central Heat Pump Split System with Evaporator Coil & Modular Blower |
| Nominal Capacity | 2 Tons |
| SEER2 | 19.0 |
| HSPF2 | 8.6 |
| EER2 | 11.0 |
| Cooling Capacity (95°F) | 23,200 BTU/h |
| Heating Capacity (47°F) | 23,200 BTU/h |
| Heating Capacity (5°F) | 15,800 BTU/h |
| Refrigerant | R-32 |
| Refrigerant Charge | 76 oz (for 15 ft line set) |
| Expansion Device | EEV (Electronic Expansion Valve) |
| Compressor Type | Variable-Speed Swing |
| Outdoor Unit Voltage | 208-230V / 1 Phase / 60 Hz |
| Outdoor Unit MCA | 22.4 Amps |
| Outdoor Unit MOCP | 25 Amps |
| Outdoor Unit Dimensions (WxDxH) | 36⅝" x 13¾" x 27⅜" |
| Outdoor Unit Weight | 132 lbs (Equipment) / 147 lbs (Shipping) |
| Sound Level (Cooling, Normal Mode) | 67 dBA (Sound Power) |
| Sound Level (Quiet Mode, Lowest) | 45 dBA |
| Evaporator Coil Model | CAPEA3626C3 |
| Coil Configuration | Upflow/Downflow |
| Coil Dimensions (WxDxH) | 21" x 21" x 26" |
| Coil Ship Weight | 57 lbs |
| Modular Blower Model | MBVK16CP1X00 |
| Blower Configuration | Multi-Positional |
| Blower Dimensions (WxDxH) | 21" x 21" x 30" |
| Blower Motor | ¾ HP Variable-Speed ECM |
| Blower Ship Weight | 80 lbs |
Note: See 'Resources (System Manuals and Warranty)' Tab above for full specifications.
Compliance & Environmental Data
| Category | Details |
|---|---|
| Refrigerant Type | R-32 (Difluoromethane, A2L Classification) |
| Global Warming Potential (GWP) | 675 (approximately 68% lower than R-410A) |
| EPA Section 608 | Universal certification required for all technicians handling R-32. A2L refrigerant handling procedures apply per UL 60335-2-40. |
| AHRI Certification | Yes — Certificate #215433908 |
| ENERGY STAR® | Cold Climate Certified; ENERGY STAR Most Efficient 2025 |
| Regional Compliance | Meets DOE 2023 minimum efficiency standards for all U.S. climate regions. Verify local jurisdiction has adopted A2L refrigerant provisions (2024 UMC or equivalent). |
| Federal Tax Credit Eligibility | Systems meeting CEE highest efficiency tier requirements may qualify for federal tax credits under the Inflation Reduction Act (IRA) §25C. Consult a qualified tax professional for eligibility based on installed system SEER2/HSPF2 ratings. |
| Florida Building Code | When properly anchored, outdoor unit meets 2023 Florida Building Code unit integrity requirements for hurricane-type winds. |
Warranty & Registration
Each component in this system carries its own manufacturer warranty from Daikin Comfort Technologies. Registration within 60 days of installation is strongly recommended to obtain the full warranty coverage described below.
- GZV7SA2410 Heat Pump Condenser: Unregistered (Initial Term): 5-year parts limited warranty. Registered (within 60 days): 10-year parts limited warranty plus 10-year unit replacement limited warranty for compressor failure (one-time replacement of entire outdoor unit). Quiet-mode, variable-speed swing compressor, and all factory-installed components are covered under parts warranty. Registration at www.goodmanmfg.com.
- CAPEA3626C3 Evaporator Coil: Unregistered (Initial Term): 5-year parts limited warranty. Registered (within 60 days): 10-year parts limited warranty covering the all-aluminum coil, internal EEV, R-32 sensor, and all factory-installed components. Registration at www.goodmanmfg.com.
- MBVK16CP1X00 Modular Blower: Unregistered (Initial Term): 5-year parts limited warranty. Registered (within 60 days): 10-year parts limited warranty covering the variable-speed ECM blower motor and all factory-installed components. Registration at www.goodmanmfg.com.
Warranty terms apply to units installed in owner-occupied residences within the United States, its territories, or Canada. Different warranty terms apply to non-owner-occupied residences and commercial installations. Some states and provinces do not allow warranty coverage to be conditioned on registration. Refer to the complete warranty document for full terms, conditions, limitations, and exclusions.
Let customers speak for us
What customers think about the store
Store offers excellent customer service with fast shipping and competitive pricing. Products arrive well-packaged and on time. Knowledgeable support staff assist with installations and technical questions. Customers appreciate quality HVAC systems, mini-splits...