This Goodman 3-Ton Central Heat Pump Split System with Evaporator Coil & Modular Blower pairs the GZV9SA361C variable-speed, inverter-driven R-32 heat pump condenser with the CAPEA6030D3 Cased Upflow/Downflow A-Coil and MBVK16CP1X00 multi-positional modular blower. This AHRI-certified combination (Certificate #216699918) achieves up to 19.0 SEER2 / 9.2 HSPF2 / 11.7 EER2, qualifying for ENERGY STAR® Most Efficient 2025 and Cold Climate Heat Pump (ccHP) designation. The system operates on low-GWP R-32 refrigerant (GWP: 675), supporting the EPA AIM Act phasedown requirements and potentially qualifying for federal energy efficiency tax credits under IRS Section 25C.
Note: If you would like to review the manufacturer Product Specifications, Warranty, Brochure, etc., for this system, please refer to the 'Resources (System Manuals and Warranty)' Tab above on this page.
System Components
- GZV9SA361C (GZV9SA361C*) — 3-Ton Variable-Speed, Inverter-Driven, Side-Discharge R-32 Heat Pump Condenser with dual variable-speed swing compressors, EEV metering, quiet-mode capability (as low as 45 dBA), and hot gas base pan defrost down to 5°F. 208-230V / 1 Phase / 60 Hz.
- CAPEA6030D3 — Cased Upflow/Downflow A-Coil, Upflow/Downflow configuration, 24½"W x 21"D x 30"H cabinet. All-aluminum 7mm tube coil with factory-installed R-32 refrigerant sensor.
- MBVK16CP1X00 — Multi-Positional Modular Blower, ¾ HP variable-speed ECM, 21"W x 21"D x 30"H, 208/230V.
⚙ Pro-Installer Tip
[Technical Friction] The coil-plus-modular-blower configuration requires careful alignment between the CAPEA6030D3 coil and MBVK16CP1X00 blower section. The joint between the two cabinets must be sealed with the factory gasket (part #0154D20003S) to prevent condensate migration and air leakage. Verify the blower orientation matches the intended airflow direction before securing—the MBVK is multi-positional, but the coil drain must face the correct direction for condensate management.
[Long-Term Prevention] After assembly, perform a static pressure test across the coil/blower combination. Target below 0.5" w.c. total external static to ensure the ¾ HP ECM motor operates within its design envelope. Excessive static from undersized ductwork will cause the motor to ramp to maximum speed, increasing noise and reducing the blower's service life. Install a condensate management kit (MBK0002) if the system is in a high-humidity environment.
[Expert Validation] Use a digital manometer with static pressure probes at the supply and return plenums. Verify subcooling at the outdoor unit service valve reads 11±1°F with an R-32-compatible digital manifold. The EEV in the GZV9S condenser auto-controls superheat—erratic readings indicate charge or airflow issues.
[Professional Standard] EPA Section 608 certification is required for R-32. The coil's factory-installed R-32 sensor and the GZV9S condenser's onboard refrigerant detection comply with UL 60335-2-40 safety requirements for A2L refrigerants. Verify local code adoption of A2L-rated equipment before installation.
Key Performance Benefits
- Cold Climate Heat Pump Certification: The GZV9S operates down to -20°F ambient, providing reliable heat pump heating in extreme cold without solely relying on auxiliary heat, reducing energy consumption in northern climates.
- Variable-Speed Inverter Efficiency: The swing compressor modulates capacity from approximately 25% to 100% (and boost mode), maintaining tighter temperature control (±0.5°F) and reducing on/off cycling compared to single-stage or two-stage systems.
- Quiet Operation: The GZV9S features three selectable quiet-mode levels with sound output as low as 45 dBA in quiet mode—comparable to a quiet library. Standard cooling mode measures approximately 59 dBA @ 5 ft (1 reflective surface).
- Low-GWP R-32 Refrigerant: R-32 has a Global Warming Potential of 675, approximately 68% lower than R-410A (GWP 2,088). This reduces the system's direct environmental impact while also improving thermodynamic efficiency due to R-32's higher volumetric capacity.
- Modular Configuration Flexibility: The separate coil and blower design allows field-configurable orientation (upflow, downflow, horizontal) to match the installation site, with standard 21" depth across all components for consistent ductwork sizing.
- EEV Metering with Auto-Controlled Superheat: The electronic expansion valve in the GZV9S condenser provides precise refrigerant metering across the full modulation range, maintaining rated efficiency from minimum to maximum compressor speed.
Technical Specifications
| Specification | Value |
|---|---|
| AHRI Certificate # | 216699918 |
| System Type | Central Heat Pump Split System with Evaporator Coil & Modular Blower |
| Nominal Capacity | 3 Ton |
| SEER2 | 19.0 |
| EER2 | 11.7 |
| HSPF2 | 9.2 |
| Max. Cooling Capacity (95°F) | 34,200 BTU/h |
| Max. Heating Capacity (47°F) | 34,200 BTU/h |
| Refrigerant | R-32 |
| Expansion Device | Electronic Expansion Valve (EEV) |
| Compressor Type | Variable-Speed Inverter-Driven Swing |
| Condenser Dimensions (W×D×H) | 37"W x 12⅝"D x 56 5/16"H |
| Condenser Weight | 230 lbs |
| Condenser Voltage | 208-230V / 1 Phase / 60 Hz |
| MCA / MOCP (Condenser) | 21.8A / 25A |
| Liquid Line / Suction Line | ⅜" / ⅞" |
| Factory Refrigerant Charge | 162 oz |
| Ambient Operating Range (Cooling) | 0°F to 115°F |
| Ambient Operating Range (Heating) | -20°F to 70°F |
| Evaporator Coil Model | CAPEA6030D3 |
| Coil Configuration | Upflow/Downflow |
| Coil Dimensions (W×D×H) | 24½" x 21" x 30" |
| Modular Blower Model | MBVK16CP1X00 |
| Blower Dimensions (W×D×H) | 21" x 21" x 30" |
| Blower Motor | ¾ HP |
| Blower Voltage | 208/230V |
| Coil-to-Condenser Fit | 1.75 |
| ENERGY STAR® | ENERGY STAR Most Efficient 2025 |
| Cold Climate HP | Yes |
Note: See 'Resources (System Manuals and Warranty)' Tab above for full specifications.
Compliance & Environmental Data
| Category | Details |
|---|---|
| Refrigerant Type | R-32 (Difluoromethane) — A2L (Mildly Flammable) |
| Global Warming Potential (GWP) | 675 (68% lower than R-410A) |
| Ozone Depletion Potential (ODP) | 0 |
| EPA Section 608 Certification | Required for purchase, handling, and installation |
| EPA AIM Act Compliance | Compliant — R-32 is an approved low-GWP alternative under the AIM Act phasedown schedule |
| UL Safety Standard | UL 60335-2-40 (A2L refrigerant safety) |
| AHRI Certification | AHRI Certified — Certificate #216699918 |
| ENERGY STAR® | Most Efficient 2025 — Cold Climate Heat Pump |
| Federal Tax Credit Eligibility | Potentially eligible under IRS Section 25C (up to $2,000) for qualifying heat pump systems meeting CEE highest efficiency tier — verify with tax professional |
| Regional Compliance | Verify local AHJ acceptance of A2L refrigerant equipment. Most jurisdictions adopting 2021+ IMC/UMC codes permit A2L installations. |
Warranty & Registration
All warranty terms below require online registration at www.goodmanmfg.com within 60 days of installation to receive the full Registered Additional Term Warranty. Without registration, coverage defaults to the Initial Term Warranty (5-year parts). Registration is not required in California, Florida, or Québec.
- GZV9SA361C (Heat Pump Condenser): 10-Year Parts Limited Warranty and 10-Year Unit Replacement Limited Warranty (if compressor fails within the first 10 years of registered ownership, Daikin will furnish an equivalent replacement unit, one time). One-time Compressor Replacement coverage is available for years 11–99 through an ASURE Extend Service Plan.
- CAPEA6030D3 (Evaporator Coil): 10-Year Parts Limited Warranty when properly registered. Covers all parts that fail under normal use and maintenance during the warranty period.
- MBVK16CP1X00 (Modular Blower): 10-Year Parts Limited Warranty when properly registered. Covers the ECM blower motor and all other parts that fail under normal use and maintenance.
Complete warranty details are available from your local dealer or at www.goodmanmfg.com. The duration of warranty coverage in Texas and Florida may differ in some cases. Units must be installed by a licensed contractor adhering to all applicable federal, state, and local codes.
Let customers speak for us
What customers think about the store
Store offers excellent customer service with fast shipping and competitive pricing. Products arrive well-packaged and on time. Knowledgeable support staff assist with installations and technical questions. Customers appreciate quality HVAC systems, mini-splits...