This is a communication cable, not a battery. It connects the ETHOS Control Box to your inverter so the two components can talk to each other. No amps flow through it, no voltage rating applies, and it does not carry power to your load.
Note: If you would like to review the manufacturer Product Specifications, Warranty, Brochure, etc., for this system, please refer to the "Resources (System Manuals and Warranty)" Tab above on this page.
Why This Cable Matters
Communication cables get overlooked in system planning, but they are what let your ETHOS Control Box and inverter coordinate charge and discharge behavior. Using the correct comm cable, rather than an improvised substitute, keeps the data link stable and avoids intermittent faults that can look like a battery problem but are really a wiring problem.
Cable Characteristics
This is a Comm-to-Comm cable designed to link an ETHOS Control Box to a compatible inverter. The manufacturer data provided does not specify gauge, weight, cable length in numeric form beyond the stated 6.6 ft, or a maximum rated temperature.
Gauge: [NEEDS VERIFICATION]
Weight: [NEEDS VERIFICATION]
Max. Rated Temperature: [NEEDS VERIFICATION]
Wiring & Configuration Limits
This cable is a signal/communication link only. It is NOT a power or battery interconnect cable, and it is NOT rated for series or parallel battery wiring of any kind. Do not substitute it for a DC power cable, and do not use a DC power cable in its place — comm cables and power cables are not interchangeable even if connectors appear similar.
Pro-Installer Tip
Mismatched or damaged comm cables are a common source of "phantom" BMS lockouts or inverter communication errors that get mistaken for battery faults. Over time, a loose or pinched comm connector can cause intermittent signal dropout, which some inverters interpret as a fault condition and use to halt charging or discharging. Before troubleshooting a battery or inverter as defective, confirm comm cable seating and continuity with a basic multimeter continuity check. As a professional standard, treat comm cable integrity checks as part of routine system maintenance, the same way you would check torque on power lugs.
Key Benefits
- Purpose-built Comm-to-Comm connector for ETHOS Control Box to inverter linkage
- 6.6 ft length for standard control box-to-inverter placement
- Simplifies system setup by matching manufacturer-specified wiring
Technical Table
| Spec | Value |
|---|---|
| Connector Type | Comm to Comm |
| Cable Length | 6.6 ft |
| Gauge | [NEEDS VERIFICATION] |
| Weight | [NEEDS VERIFICATION] |
| Max. Rated Temperature | [NEEDS VERIFICATION] |
Note: See "Resources (System Manuals and Warranty)" Tab above for full specifications.
Compatibility & Fitment
Compatible with: ETHOS Control Box units requiring a comm connection to a compatible inverter.
NOT compatible with: use as a DC power or battery interconnect cable. NOT intended for series or parallel battery bank wiring. NOT a substitute for manufacturer-specified power cabling. This cable does NOT include a battery, control box, or inverter — those components are sold separately.
Options & SKUs
| Variant | SKU | Price |
|---|---|---|
| Standard | CBL096-K | $10.00 |
FAQ
Is this cable used to carry battery power?
No. It is a communication cable only, linking the ETHOS Control Box to an inverter for data exchange. It does not carry charge or discharge current.
Can I use this cable to connect batteries in series or parallel?
No. This cable is not rated or designed for series or parallel power wiring between batteries.
What length is this cable?
It is 6.6 ft long.
Does this cable come with the ETHOS Control Box or inverter included?
No. This listing is for the comm cable only. The control box and inverter are sold separately.
Warranty & Support
For warranty terms and manufacturer documentation, check the "Resources (System Manuals and Warranty)" Tab above. If you have questions about compatibility with your specific ETHOS or inverter setup, ask us before you order — we always reply back.
