This is a direct-replacement toggle switch for PolarCool 48" 120V evaporative coolers, used to control the fan motor or water pump. If your existing switch has failed or feels loose, this restores manual on/off control.
Part No. 3001-2868 is a genuine PolarCool replacement switch, built for repeated switching cycles in industrial and outdoor cooling environments. It restores manual control on portable evaporative air coolers, swamp coolers, and industrial air coolers where the original switch has worn out or failed. Note: If you would like to review the manufacturer Product Specifications, Warranty, Brochure, etc., for this system, please refer to the "Resources (System Manuals and Warranty)" Tab above on this page.
Critical Fitment & Requirements
- Voltage rating: 120V only.
- System compatibility: PolarCool 48" (120V only) evaporative coolers.
- Verified compatible fan model: SKU 6622-1310 only.
- Switch type: DPST (Double Pole, Single Throw) toggle switch.
- Does NOT have confirmed compatibility with fan models other than SKU 6622-1310 — verify your model before purchase.
- Not intended for pump operation without water present in the reservoir; dry-running the pump switch can cause pump damage.
Toggle switches in outdoor and industrial cooler cabinets take a beating from vibration and repeated cycling, and a loose mounting nut is the most common cause of a switch that "feels dead" even when wiring is intact. Snug the panel nut down fully and check it again after the first week of operation — vibration from the fan motor will back off a nut that isn't seated tight, and that leads to arcing at the terminals over time. Use a proper nut driver (not pliers, which can round the hex) to seat it, and always de-energize the circuit at the breaker before you touch the terminals. Follow standard electrical safety procedure for any 120V component replacement — verify the circuit is dead with a non-contact voltage tester before wiring in the new switch.
Key Benefits
- Genuine PolarCool replacement component, not a generic aftermarket substitute.
- DPST design controls two circuits from a single toggle for fan or pump switching.
- Built for repeated switching cycles in demanding outdoor and industrial cooling environments.
- Straightforward installation for maintenance teams and facility operators.
| Spec | Value | Unit |
|---|---|---|
| Voltage Rating | 120 | V |
| System Size | 48 | in |
| Switch Type | DPST (Double Pole, Single Throw) | — |
| Compatible Fan SKU | 6622-1310 | — |
| Part Number | 3001-2868 | — |
Note: See "Resources (System Manuals and Warranty)" Tab above for full specifications.
Compatibility & Fitment
- Fits: PolarCool 48" 120V evaporative cooling systems, including portable evaporative air coolers, swamp coolers, and industrial air coolers.
- Fits: Systems using fan SKU 6622-1310.
- Does NOT fit: Coolers rated for voltages other than 120V.
- Does NOT have confirmed fitment with fan models other than SKU 6622-1310 — verify before ordering.
| Consideration | Guideline |
|---|---|
| Water Reservoir | Pump switch should only be activated when water is present in the reservoir |
| Electrical Safety | Follow proper electrical safety procedures during installation and replacement |
FAQ
Will this wall sleeve fit a standard 42x16 cutout?
Not applicable — this is a toggle switch, not a PTAC wall sleeve. It is rated for PolarCool 48" 120V evaporative coolers only.
What voltage is this toggle switch rated for?
This switch is designed for 120V systems only. It is built for PolarCool 48" 120V evaporative coolers.
Will this switch fit any PolarCool cooler?
No. This switch is intended for use with fan SKU 6622-1310 only. Verify compatibility with your specific model before ordering.
Can I use this switch to control the water pump?
Yes, it can control either the fan motor or the water pump circuit. Only activate the pump switch when water is present in the reservoir.
Is this a genuine PolarCool part?
Yes, Part No. 3001-2868 is a genuine PolarCool replacement component.
What type of switch is this (mechanically)?
It is a DPST (Double Pole, Single Throw) toggle switch.
Warranty & Registration
Manufacturer warranty terms for this component are not detailed in the provided source data. [NEEDS VERIFICATION] Refer to the "Resources (System Manuals and Warranty)" Tab above on this page for manufacturer warranty terms, registration steps, and full documentation. Ask us before you order if you need help confirming warranty coverage for your specific unit.
